7. Advanced
SOURCE = Mono
@60Hz
ASYNC
48
Image 7-146
Mono source : Full screen synchronous representation ON and Stereo Mode = Auto
Stereo Sources
When a stereo source is connected to the projector following settings can change the way it is displayed :
•
Full screen synchronous representation
Following illustrations give an overview on how a stereo source will be displayed in function of its vertical refresh rate and for the
different settings mentioned above.
SOURCE = stereo
@120Hz
@2Xf source
ASYNC
48
Image 7-147
Stereo source : Full screen synchronous representation ON
SOURCE = stereo
48
Image 7-148
Stereo source : Full screen synchronous representation OFF
7.9.2.2
Stereo Mode
What can be done ?
The stereo mode in the display setup menu is the mode in which the display is driven.
Following modes are available :
AUTO
ALWAYS
INFITEC
Table 7-8
Stereo Mode
132
FULL SCREEN SYNCHRONOUS MODE = on
STEREO MODE = auto
FULL SCREEN SYNCHRONOUS MODE = on
@120Hz
SYNC
ASYNC
60
FULL SCREEN SYNCHRONOUS MODE = off
the display is driven in stereo if the source is stereo (sync signal on the corresponding mini DIN connector)
the display is always driven in stereo independently of the source (stereo or mono)
the display is always driven in Infitec mode (infitec wheel system is activated) independently of the source
(stereo or mono)
@f source
SYNC
@f source
SYNC
96
@120Hz
ASYNC
R59770288 GALAXY NW-12, GALAXY NW-7 20/06/2013
@60Hz
ASYNC
120
f(Hz)
@120Hz
ASYNC
120
f(Hz)
120
f(Hz)