Trouble Shooting; Error Codes; Introduction; Overview Of The Error Codes - Barco Galaxy NW-12 User Manual

9. TROUBLE SHOOTING

Overview
•

Error codes

• Trouble shooting through the OSD
• Basic troubleshooting guide
9.1 Error codes
9.1.1

Introduction

Error display
The LCD module is located at the front side of the projector underneath the input module. It will display error codes in case a problem
is encountered.
Galaxy NW-12
P11 Power Fail
Image 9-1

LCD Display : error display

Syntax of the error codes
The error code exists out of a prefix, two digits and a short message. E.g.
• T: temperature error
• F: fan error
• L: lamp error
• P: power error
• H: hardware error
If ever you have to contact Barco's Helpdesk concerning an error code, make sure to mention the prefix and
both digits, since this data is most useful for Barco engineers to determine which actions have to be taken.
9.1.2

Overview of the error codes

Temperature errors
Description
Air pressure
Microcontroller
PFC heat sink
Ambient
Air pressure
Microcontroller
SMPS heat sink
Ambient
Lamp overtemperature or open LPS door
DMD overtemperature
Fan errors
Description
fan top LPS
R59770288 GALAXY NW-12, GALAXY NW-7 20/06/2013
standby
Location
Prefix
PB T
PB T
PB T
PB T
XFAN T
XFAN T
XFAN T
XFAN T
T
Control engine
Controle engine T
Location
Prefix
PB F
P11 Power Fail. Possible prefixes are:
Message
Code
10 PB overtemp
11 PB overtemp
12 PB overtemp
15 PB overtemp
20 XFAN overtemp
21 XFAN overtemp
22 XFAN overtemp
25 XFAN overtemp
50 Lamp overtemp
51 DMD overtemp
Message
Code
10
LPS top fan error
9. Trouble shooting
201