Passive Infitec - Barco Galaxy NW-12 User Manual

3. Press ↓ to Pull down the Image menu
4. Use ↑ or ↓ to select Input stereo sync
5. Press → to pull down the menu
6. Use ↓ or ↑ to select Only field 1 or Only field 2
Image 7-39
7. Press ENTER
A white bullet shows the active setting
7.4.7 Passive Infitec
Introduction
Passive Infitec is the stereo technology where two projectors are used to display a stereoscopic image to viewers wearing Passive
Infitec eyewear. One projector has a "left" Passive Infitec filter and displays the left image, whereas the other projector has a "right"
Passive Infitec filter and displays the right image. When looking through Passive Infitec eyewear, a nice stereoscopic image can be
seen.
If your projector has the Passive Infitec stereo option on board, the according menu item becomes enabled. The moment you select
a Passive Infitec stereo source, you must make the selection in the OSD to move the Passive Infitec filter in the light path. While
displaying mono sources or Active (Infitec) stereo sources, the Passive Infitec filter must be moved out of the light path by selecting
the corresponding setting in the OSD.
How to move the Passive Infitec filter into the light path?
1. In the OSD, highlight Image > Passive Infitec > On
Image 7-40
2. Press Enter to confirm the selection. The Passive Infitec filter moves into the light path.
Note: It takes some time before the Passive Infitec filter has fully moved into the light path.
How to move the Passive Infitec filter out of the light path?
1. In the OSD, highlight Image > Passive Infitec > Off
R59770288 GALAXY NW-12, GALAXY NW-7 20/06/2013
7. Advanced
77