Asynchronous Frequency - Barco Galaxy NW-12 User Manual

Image 7-151
A bullet shows the active setting
7.9.3.2

Asynchronous frequency

What can be done ?
The frequency can be set to either low or high. In the synchronous mode, the display will be refreshed at the same vertical frequency
as the displayed source.
In the asynchronous mode, the display will be refreshed at a fixed vertical frequency (50/100 Hz or 60/120 Hz) depending on the
OSD setting, instead of the vertical frequency of the displayed source.
Asynchronous frequency setting is only applicable in the Galaxy NW-7.
The low and high asynchronous frequency values are 50 Hz or 100 Hz.
The high asynchronous frequency values are 60 Hz or 120 Hz.
How to set the asynchronous frequency ?
1. Press MENU to activate the Tool bar
2. Press → to select the Display setup item
3. Press ↓ to Pull down the Display setup menu
4. Use ↑ or ↓ to select Full-screen synchronous representation
5. Press → to open the menu
6. Use ↑ or ↓ to select Asynchronous frequency
7. Press → to open the menu
8. Use ↑ or ↓ to select Low or High
9. Press ENTER
R59770288 GALAXY NW-12, GALAXY NW-7 20/06/2013
7. Advanced
135