Starting Up The Projector; Standby Status - Barco Galaxy NW-12 User Manual

5. Setup
In normal conditions, the network detection takes about 25 seconds. This means that the total time needed to
go from power ON to Standby mode can take up to 85 seconds. This value can vary depending on the speed
of the network connection.
If the network cable is plugged in, but no real network is connected to it, this start-up time can take up to 120
seconds: 60 seconds where the backlight of the LCD display is ON but no message is displayed, increased
by 60 seconds during which the LCD display shows the text BOOT.
Galaxy NW-12
Image 5-3

Standby status

The standby status is shown on the LCD display. An information field will rotate between the following information strings :
• Projector name
• Hostname : this is the name defined in the network settings menu, see Network settings
• IP address
• Baudrate
• RCU private address
• RCU common address
Galaxy NW-12
Common 0
Private 1
Image 5-4
Standby status
5.2

Starting up the projector

C
AUTION
in order to reproduce initial adjustments. If the environment (e.g. ambient temperature of the surrounding)
is stable, the product will typically reproduce functional performance within 30 minutes and achieve optimal
performance after 45 minutes (advised for multichannel display systems). It should be noted that the heat
dissipation of the product itself might influence its environment; if not monitored and corrected via external
responsive temperature controls, this might affect the typical settle time required.
How to start up the projector ?
1. Press the Standby button on the RCU or on the local keypad
42
Galaxy NW-12
Hostname
150.158.193.179
57600
:
This projection product contains several optical elements which require a certain warm up time
Boot
standby
R59770288 GALAXY NW-12, GALAXY NW-7 20/06/2013