Testing The Treadmill Operation - CYBEX Pro+ Owner's Service Manual

! WARNING: Be sure that all electrical requirements are met as indicated in the
specifications at the front of the manual and at the beginning of this
chapter prior to proceeding.

Testing the Treadmill Operation

Use the following instructions to test the full speed and incline range of the treadmill and to
check the belt for proper operation.
! CAUTION: During this procedure STAY OFF THE RUNNING BELT! Stand with your feet
on the two steps.
1. Without anyone on the treadmill, plug the power cord into a power outlet from a
grounded, dedicated circuit as described under Electrical Requirements in this chapter.
2. Locate the on/off (I/O) power switch on the left side of the treadmill. Toggle it to the on
position (I).
3. The control panel will light up and be in the Dormant Mode.
NOTE: Cybex recommends that the treadmill be unplugged or the on/off (I/O) power
switch turned off (O) when it is not in use.
4. Press the Quick Start key. The treadmill begins a countdown "3...2...1" and sounds a tone
for each count. After it reaches one (1), the treadmill gives a longer tone and then begins
accelerating the belt to reach 1 mph (1.6 kph).
5. The bottom left display will flash the time and the right display will show the actual speed.
6. Press and hold down the Speed
approximately 4 mph (6.4 kph), as indicated on the display.
7. Observe the belt to see that it is running properly; it should stay centered
in the middle of the deck. If you have problems with the running belt operation, see
Running Belt Adjustments in the Preventive Maintenance chapter.
8. Run the treadmill through its full speed range. First press the Speed
treadmill reaches its highest speed, 12.4 mph (20 kph). Then press the Speed
the treadmill is back to 1.0 mph (1.6 kph).
9. As you press the Incline
actual incline or speed.
10. When the treadmill reaches the set incline and speed, the displays will stop flashing and
remain steadily illuminated to indicate that the desired settings have been reached.
Cybex Pro+ Treadmill Owner's & Service Manual
+
key until the treadmill reaches a speed of
+ -
or Speed keys, the respective displays will show the
+
key until the
-
key until
Page 5-11
Setup
&
Assembly