CYBEX Pro+ Owner's Service Manual page 43

Figure 3
4. Remove the side panels.
A. Pull each side panel out and off the treadmill. See Figure 3.
5. Remove the top steps.
A. Using a Phillips head
screwdriver, remove the three
screws that hold each top step in
place. See Figure 4.
B. Grasp each top step and lift it
out and off the treadmill. See
Figures 3 and 4.
6. Check the belt and deck
condition.
A. Look at the edges of the belt while you roll it by hand. If the belt has any rips or looks
excessively worn the belt needs to be replaced.
B. Run your hand under the belt on the top of the deck surface. If you feel excessive
ridges or cracks, or if the deck feels grooved yet highly polished, the deck should be
flipped to an unused surface or replaced. In time, a worn belt and deck can cause
high current draw and ultimately, motor failure. For instructions on replacing the belt
and deck, see Running Belt and Deck in the Service chapter.
7. Clean under the belt.
A. To minimize the effect of friction between the deck and the running belt, Cybex
recommends cleaning the underside of the running belt and the top of the running
deck surface by wiping them with a clean, dry towel. This cleaning should be
done each time you check the belt and deck condition to prevent premature wear
of the deck, running belt and the drive motor system. See the Service Schedule in
this chapter.
Cybex Pro+ Treadmill Owner's & Service Manual
Top Steps
Side Panel
Figure 4
Side Panel
End Caps
Screws
Screws (3 Under Each Top Step)
Preventive
Maintenance
Page 4-5