Line Filter - CYBEX Pro+ Owner's Service Manual

Cardiovascular systems
Hide thumbs Also See for Pro+:
Table of Contents

Advertisement

Line Filter

NOTE: If you are replacing the line filter follow steps 7 and 8. If not skip to step 9.
7. Replace the line filter (optional).
A. Disconnect the fast-on that goes from the line filter to the drive motor (green cable).
B. Disconnect the two fast-ons that go from the line filter to the lower board (cables
labeled AC Line 1 and AC Line 2 on the lower board).
C. Using a Phillips head screwdriver, remove the two screws that hold the line filter to the
lower control bracket and discard the old line filter if applicable.
D. Place the new line filter in position on the lower control bracket.
E. Using a Phillips head screwdriver, secure the two screws that hold the line filter to the
lower control bracket.
8. Connect the line filter cables (if applicable).
A. Connect the white cable to the front right fast-on on the line filter and route it through
the access hole.
B. Connect the black cable to the front left fast-on on the line filter and route it through
the access hole.
C. Connect the ends of these two cables to the lower board. The white connects to the
fast-on labeled AC Line 1. The black connects to the fast-on labeled AC Line 2.
D. Connect the drive motor cable (green) to the line filter's front left fast-on connector.
9. Route the power cord.
A. Route the power cord behind the base brackets and route the fast-ons out the power
switch access hole. NOTE: The power cord can exit the front or back of the treadmill.
Position it the way you intend to leave it.
10. Connect the power cable.
A. Hold the power switch and its plate so that the I (on) is toward the top. See Figure 23.
B. Connect these two power cord cables to the power switch:
• The blue cable connects to the top left switch fast-on.
• The brown cable connects to the top right switch fast-on
NOTE: You will connect the ground in step 10D.
C. Connect the line filter fast-ons to the power switch.
• The white cable connects to the bottom right switch fast-on.
• The black cable connects to the bottom left switch fast-on
Service
Page 7-28
Cybex Pro+ Treadmill Owner's & Service Manual

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents