Led Functions; Key Functions - CYBEX Pro+ Owner's Service Manual

LED Functions

LEDs are used to indicate the status of many of the treadmill inputs. After entering Test Mode
refer to the following list to check that these LEDs are functioning properly:
Heart LED — Blinks on with every signal from the contact heart rate receiver.
Weight LED — Blinks on when CSAFE data is being received.
Level LED — Blinks on when CSAFE data is being transmitted.
Lower Left Window — The numbers indicate actual elevation. A '-' sign indicates the treadmill
is below 0% grade. The decimal point before the numbers shows the activation of the 0% switch
in the elevation motor (on above 0%). If dashes are shown in the display, the treadmill is either
above or below the 0% switch, requiring it to be manually run through the switch to begin
indicating actual elevation. The right most decimal point indicates the status of the E-stop relay,
on when the E-stop relay is on, off when it is deactivated. NOTE: The right most decimal point
may be difficult to see. Lean your head to the left to see this.
Lower Right Window — The numbers indicate actual belt speed. The right most decimal point
indicates the pulses from the speed sensor on the motor.

Key Functions

While in Test Mode press the following keys for desired information:
Quick Start — Starts the belt at 1.0 mph (1.6 kph). Also will run calibration if held for 3 seconds.
Heart Rate Program key — Lights all of the LEDs for a short period of time.
Weight Loss key — Lights only the columns.
9 Holes key — Lights only the rows.
Incline — Run elevation motor up.
Incline — Run elevation motor down.
+
Speed — Increase drive motor speed.
-
Speed — Decrease drive motor speed.
Distance — Press once for odometer information (DST) to appear in the speed window.
Press again for hourmeter information (HRS) to appear in the speed window.
Press three times for number of starts information (USES) to appear in the speed window.
Press four times for brush wear mileage up to 100 miles since activated or "0" if it has not been
activated (BRSH).
Pace — Displays and cycles through error log. Up to 10 errors can be stored.
Scan — Clears error log when pressed twice while in error log mode.
Mets — Value of motor load in A/D counts. The number range is relative to motor current and
goes from 0-225. (LOAD).
Calories — Displays motor pulse width (PWM) value.
Enter — Required to save setup values.
Cybex Pro+ Treadmill Owner's & Service Manual
Service
Page 7-3