Display Cable - CYBEX Pro+ Owner's Service Manual

B. Using a Phillips head screwdriver, remove the three screws that hold the CSAFE board to
the console.
4. Attach the new CSAFE board.
A. Gently push the CSAFE connector into its port on the display board. See Figure 24.
B. Using a Phillips head screwdriver, secure the CSAFE board with the three screws removed
during step 3B. NOTE: Do not overtighten.
5. Secure the console back.
A. While being sure not to pinch any cables, use a Phillips head screwdriver to secure the
nine screws that hold the console back to the console front.

Display Cable

Tools Required
• Phillips head screwdriver
• ESD (Electro Static Discharge) grounding strap
• Wire cutters
! WARNING: Disconnect the power cord before beginning this procedure. Keep wet items
away from inside parts of the treadmill. Electrical shock could occur even if
the treadmill is unplugged. Do not touch components on the lower board. A
charge can remain after unplugging the power cord and turning off the
treadmill.
1. Disconnect the external power source.
A. Turn the main power switch on the left side to the off (O) position.
B. Unplug the treadmill from the power outlet.
NOTE: The display board is susceptible to damage from a discharge of static electricity. While
handling parts underneath the console cover use an ESD grounding strap. This eliminates
the potential voltage (static) difference between you and the equipment you are working
on. Wear an ESD strap for the rest of this procedure.
2. Remove the console back.
A. Using a Phillips head screwdriver, remove the nine screws that hold the console back to
the console front.
B. Gently pull off the console back.
3. Remove the motor cover.
A. Using a Phillips head screwdriver, loosen three screws on each motor cover side (left and
right). See Figure 2.
Cybex Pro+ Treadmill Owner's & Service Manual
Service
Page 7-35