CYBEX Pro+ Owner's Service Manual page 97

6. Route the new heart rate cable.
A. Connect the double connector into the right side of the heart rate board. See Figure 25.
B. Locate the short and long side of the heart rate
cable.
C. Route the short cable end to the left (from treadmill
user's viewpoint) and the long end to the right.
D. Place the cable behind the handrail and tie with four
wire ties in the locations they were removed in step
5D.
E. Fold the each cable and place it into the hole that
leads to the grip. See Figure 27.
F. Push each wire out a hole (red out the front hole and
black out the back hole). See Figure 27.
7. Secure the new plastic housing.
A. Slide an o-ring on each handrail and roll it over the
wires so that it is positioned just after the hole where
the wires emerge. See Figure 27.
B. Remove the protective paper from the loose pieces
double-sided tape and stick each one between two
small holes in the handrail. See Figure 28.
C. Position each set of plastic housing so that the
grooves fit together snugly. NOTE: If the grooves
don't fit and the housing gets taped down in the
wrong position pulling it up will destroy the tape. Do
not let the plastic housing touch the double-sided
tape until step 7E.
D. Place each plastic grip near the handrail and pull
each wire through a rectangular hole. See Figure 29.
NOTE: Don't let the wires slip back into their holes.
E. Fit the three plastic parts in position (the housing (2)
and the cap (1)) and continue holding all plastic parts
through the next step. See Figure 29.
F. While being careful not to overtighten and crack the housing,
place the nuts in their holes and secure them with the bolts.
NOTE: It is easier to place the nuts on the top and the bolts from
the bottom. See Figure 30.
8. Secure the new metal contacts.
A. Remove the protective paper from the four metal contacts and from
the eight strips of tape on the plastic housing.
Cybex Pro+ Treadmill Owner's & Service Manual
Black Wire
(Back)
O-Ring
Cable
Enters
NOTE: Front is from treadmill
Hole
user's viewpoint.
Figure 27
Small Holes
Figure 28
Figure 29
Nuts
Figure 30
Red Wire
(Front)
Double-sided
Tape
Cap
Double-sided
Tape
Wire Through
Rectangular
Hole
Bolts
Service
Page 7-33