CYBEX Pro+ Owner's Service Manual page 53

Figure 7
B. Using the hex key provided, tighten the two pivot screws on the handrail. See
Figure 8.
Figure 8
9. Remove the left side panel.
A. Pull the left side panel away from the base. See Figure 9.
Left Side Panel
Figure 9
10. Arrange power cord.
A. Decide whether you will plug the power cord into an outlet near the front of the
treadmill or the back of the treadmill. Follow the corresponding routing procedure
below. NOTE: Do not plug in the power cord at this time.
Cybex Pro+ Treadmill Owner's & Service Manual
Pivot
Screws
3
Setup
&
Assembly
Page 5-7