CYBEX Pro+ Owner's Service Manual page 101

Console
Back Cover
Screws (9)
Figure 33
Secure the cable.
A. Using a Phillips head screwdriver, open the clip described in step 5D and secure the cable
in the clip.
B. Locate the line on the display cable described in step 6D and tie the cable with the wire
tie near the bottom of the upright.
C. Open the wire holder at the junction, put the cable inside and close the wire holder.
D. Check to see that all of the connectors are connected firmly in their proper place.
Cybex Pro+ Treadmill Owner's & Service Manual
P3 and P8
Connectors on
Upper Display
Board
Shield
P1 and P2 on
Lower Board
NOTE: "Right" and "left" denote
user orientation.
Wire
Screws (3)
Holder
Display Cable
Upright
Access
Hole
7.
Bottom
Hole
Left
Junction
Covers
Screws (4)
Left Side Cover
Page 7-37
Service