Power Switch - CYBEX Pro+ Owner's Service Manual

2. Remove the motor cover.
A. Using a Phillips head screwdriver, loosen three screws on each motor cover side (left and
right). See Figure 2.
B. Lift the motor cover center up and off the treadmill. The screws will stay in place. See
Figure 2.
C. Remove the left plastic side cover.
3. Remove the left end cap.
A. Using a Phillips head screwdriver, remove the screw that holds the left end cap in place.
See Figure 4.
4. Remove the left side panel.
A. Pull the left side panel out and off the treadmill.

Power Switch

5. Remove the power switch.
A. Using a Phillips head screwdriver, remove the two screws that hold the switch and its
plate to the treadmill.
B. Disconnect the four fast-on connectors that go into the power switch.
C. Using a 3/8" nutdriver, remove the one nut and one washer from the ground wire on the
lower control bracket.
6. Remove the power cord.
A. Remove the old power cord and discard the power cord (and power switch if applicable).
See Figure 22.
Power Cord
Grommet
Figure 22
Cybex Pro+ Treadmill Owner's & Service Manual
Shield
Power Switch
Wire Tie
Plate
Service
Page 7-27