JRC JSS-2150 Instruction Manual page 98

Operation
4 . 5 . 1 . 3 Other features of safety calls
4 . 5 . 1 . 3
Use safety calls to request the position information to a station or to make a DSC test call.
(1) Position request call
■ ■
Procedure
1 .
1 .
1 .
Press
MENU
hierarchical menus, select 1. DSC
non-distress call.
2 .
2 .
2 .
Select Call type and press ENT to move
the cursor to the right. Then use the jog
dial to select SAF/Indv/PosRQ.
3 .
3 .
3 .
Press ENT.
The display changes as shown to the right
and the cursor moves to Address.
4 .
4 .
4 .
Select Address and press ENT to move
the cursor to the right and input the
station's 9-digit MMSI.
5 .
5 .
5 .
To change the call frequency, select
Calling FRQ and press ENT to move the
cursor to the right. Then select the
distress and safety frequencies using the
jog dial and press ENT.
- The numeric keypad can also be
Note
used.
- For information on distress and
safety calls, See "11.1 Frequencies
for distress and safety calls".
- After input is complete, check the
details of the message before
sending it using Preview.
4-48
key, and through
(position request/test)
1)DSC non-distress call
Call type
Address
Calling FRQ:[Tx
Working FRQ:[Tx
[Call] [Preview]
1)DSC non-distress call
Call type
Address
Calling FRQ:[Tx
Working FRQ:[Tx
[Call] [Preview]
1)DSC non-distress call
Call type
Address
Calling FRQ:[ 2187.5kHz]
[Call] [Preview]
1)DSC non-distress call
Call type
Address
Calling FRQ:[ 2187.5kHz]
[Call] [Preview]
1)DSC non-distress call
Call type
Address
Calling FRQ:[ 4207.5kHz]
[Call] [Preview]
:[RTN/Indv/TEL ]
:[ ]
2177.0kHz]
:[Rx 2177.0kHz]
. kHz]
[Rx . kHz]
[Cancel]
:[SAF/Indv/PosRQ]
:[ ]
2177.0kHz]
:[Rx 2177.0kHz]
. kHz]
[Rx . kHz]
[Cancel]
:[SAF/Indv/PosRQ]
:[ ]
[Cancel]
:[SAF/Indv/PosRQ]
:[0 ]
[Cancel]
:[SAF/Indv/PosRQ]
:[431123456]
[Cancel]