JRC JSS-2150 Instruction Manual page 76

Operation
(2) Setting the ITU channels
■ ■
Procedure
1 .
1 .
1 .
After setting the TEL or CW communication
modes, pressing the
status display for the ITU channel mode.
2 .
2 .
2 .
Input the channel by using the numeric
keypad.
When 4 is input using the numeric
Note
keypad, it appears on the far right
as shown in the screen on the right.
3 .
3 .
3 .
Input the rest of the digits and press ENT.
The input ITU channel frequency is displayed
and the settings are complete.
- See the appendix "11.4 ITU channel list (TEL/CW/TLX)" for a list of
Note
pre-installed ITU channels and their frequencies.
- Besides doing settings with the numeric keypad, settings can also be done with
the jog dial.
The above operation is unavailable in the telex mode. The ITU channel in the
-
telex mode is set with the controller menu 5.2 ITU channel list, or the data
terminal menu operation, as Tune
4-26
CH key opens the
I D 4 3 1 0 0 1 2 3 4
P o s 8 9 ﾟ 5 9 . 0 1 2 3 ' N
1 7 9 ﾟ 5 9 . 6 7 8 9 ' E @ 2 3 : 5 9
TEL ITU-
13077.0
RX
12230.0
TX
S I G
W K R s c a n b a n d s :
2 4 6 8 1 2 1 6 ( M H z )
I D 4 3 1 0 0 1 2 3 4
P o s 8 9 ﾟ 5 9 . 0 1 2 3 ' N
1 7 9 ﾟ 5 9 . 6 7 8 9 ' E @ 2 3 : 5 9
TEL ITU- 401
4357.0
RX
4065.0
TX
S I G
W K R s c a n b a n d s :
2 4 6 8 1 2 1 6 ( M H z )
ITU channel set.
T I M E 2 3 : 5 9 ( U T C )
( E X T )
4
kHz
kHz
T I M E 2 3 : 5 9 ( U T C )
( E X T )
kHz
kHz