JRC JSS-2150 Instruction Manual page 67

7 .
7 .
7 .
To finish the communication, press F10 Stop key.
After sending the end of
communication for about five
seconds, returns to the
standby condition.
When pressing the F10 Stop
key during sending a
message, the sending
message buffer is cleared at
once and initiates the end of
communication process.
（ ２ ） Receiving CFEC broadcasting
CFEC broadcasting messages can be received on the selected work frequency.
■ ■
Procedure
1 .
1 .
1 .
If displaying the message of "Press Enter key to get the access right in the NBDP
mode..." on the data terminal, press Enter key on the keyboard.
The operation of the data
terminal becomes possible in
the telex mode, except when
the controller is used.
2 .
2 .
2 .
On the main menu and the dropdown menu, select Tune
Enter key.
The screen as shown at right
is displayed.
To input the frequency, press
Enter key to move the cursor
to the right.
To select the frequency from
the frequency list, select
Tune Frequency list and
open the frequency list of
either one of radio stations.
Operation
Tx/Rx frequency set with
4-17