Setting The Squelch Level; Setting The Cw Bandwidth - JRC JSS-2150 Instruction Manual

4.3.7

Setting the squelch level

■ ■
Procedure
1 .
1 .
1 .
Press the
MENU
hierarchical menus, after 5.4 Receiver
appears, move the cursor to 5. Squelch.
2 .
2 .
2 .
Press ENT to move the cursor to the right,
then use the jog dial or numeric keypad to
input a value in the range of 000 to 100.
After inputting and pressing ENT, the settings
are complete.
Setting the value to 000 automatically
-
Note
displays it as OFF.
- This function is invalid in the DSC
mode or the telex mode.
4.3.8

Setting the CW bandwidth

■ ■
Procedure
1 .
1 .
1 .
Press the
MENU
hierarchical menus, after 5.4 Receiver
appears, move the cursor to 6. CW
bandwidth.
2 .
2 .
2 .
Press ENT to move the cursor to the right,
then use the jog dial to select Wide or
Narrow.
After inputting and pressing ENT, the settings
are complete.
- Setting the value to 000 automatically
Note
displays it as OFF.
- This function is enabled in CW mode
only.
key, and through
key, and through
5.4)Receiver
1.Auto gain control :Slow
2.Noise reduction :OFF
3.Attenuation :OFF
4.Clarifier :+000Hz
5.Squelch :OFF
6.CW bandwidth :Narrow
7.Scan
0.Back
5.4)Receiver
1.Auto gain control :Slow
2.Noise reduction :OFF
3.Attenuation :OFF
4.Clarifier :+000Hz
5.Squelch :012
6.CW bandwidth :Narrow
7.Scan
0.Back
5.4)Receiver
1.Auto gain control :Slow
2.Noise reduction :OFF
3.Attenuation :OFF
4.Clarifier :+000Hz
5.Squelch :OFF
6.CW bandwidth :Narrow
7.Scan
0.Back
5.4)Receiver
1.Auto gain control :Slow
2.Noise reduction :OFF
3.Attenuation :OFF
4.Clarifier :+000Hz
5.Squelch :OFF
6.CW bandwidth :Narrow
7.Scan
0.Back
Operation
4-31