JRC JSS-2150 Instruction Manual page 188

Options Operation
■
Loading the printer paper
1 .
1 .
1 .
Turn the printer OFF, loosen the roll paper
stand fixing screws, and slide the stand
backwards to open the printer cover.
At this step, also remove the roll paper cover.
2 .
2 .
2 .
Pass the roll bar through the roll paper,
and install the roll paper onto the roll paper
stand paying attention to its orientation.
3 .
3 .
3 .
Pass the roll paper over the guide bar as
shown in the figure at right.
4 .
4 .
4 .
Pull the friction lever towards the front, and
insert the leading edge of the paper into
the rear of the platen. Then, return the
friction lever to the back, and turn the
paper feed knob to feed the paper out.
5 .
5 .
5 .
Lift the paper load lever up to hold down
paper fed out of the platen.
10-6
■
Fixing
screws
Roll bar
Roll paper
Guide bar
Platen
Paper
load lever