Setting Telex Mode - JRC JSS-2150 Instruction Manual

5.8 Setting telex mode

The following describes the procedure to check or set the condition for the telex communication.
■ ■
Procedure
1 .
1 .
1 .
If displaying the message of "Press Enter key to get the access right in the NBDP
mode..." on the data terminal, press Enter key on the keyboard.
The operation of the data
terminal becomes possible in
the telex mode, except when
the controller is used.
2 .
2 .
2 .
On the main menu and the dropdown menu, select System
key.
The setting conditions
concerning to the telex
communication are displayed.
3 .
3 .
3 .
Select the item to be changed with the cursor, and press Enter key.
The input screen as shown at right is
displayed.
※ An example of Max. FEC error rate
4 .
4 .
4 .
Press Enter key to move the cursor to the right. Then input the value and press Enter
key again.
The cursor moves to Set.
Settings & Registrations
NBDP setup with Enter
5-17