Communicating In Radiotelephone Mode; Communicating In Cw Mode - JRC JSS-2150 Instruction Manual

4.2.3

Communicating in radiotelephone mode

Use the handset to communicate in radiotelephone mode.
■ ■
Procedure
1 .
1 .
1 .
When operating on a controller without
access rights (OCC is displayed), press the
jog dial to obtain the access rights.
Unless the controller with access rights is being
used, the access rights are acquired and the OCC
display on the screen disappears.
2 .
2 .
2 .
Press the TEL
The communication mode is set to TEL.
Pressing the
power to the PA on and off.
If the power to the PA is on,
displayed as shown at right.
3 .
3 .
3 .
Set the frequency for making calls in
radiotelephone mode.
-
The frequency is set on the receiving
Note
status in the status display. For
details, see "4.3.1 Setting the
communication frequencies" and
"4.3.2 Setting the communication
channels".
- See the frequency for making calls
in the appendix "11.4 ITU channel
list (TEL/CW/TLX)".
4 .
4 .
4 .
Adjust the volume of the loudspeaker by
turning the volume control.
5 .
5 .
5 .
Turn the RF GAIN control to an appropriate
reception level.
key.
TEL key again turns the
TXON is
Operation
4-7