Controller Settings - JRC JSS-2150 Instruction Manual

Settings & Registrations

5.3 Controller settings

The following describes the procedure regarding individual settings for the controller such as LCD
adjustment.
5.3.1 LCD adjustment
The LCD conditions for viewability are adjustable as follows.
■ ■
Procedure
1 .
1 .
1 .
Press the
MENU
hierarchical menus, select 7.3.1 LCD
adjustment.
The screen as shown at right is displayed.
2 .
2 .
2 .
Move the cursor to the desired item and
press ENT. Then alter the settings as
appropriate with the numeric keypad or
jog dial, and press ENT again.
Set each item within the ranges given
below:
Contrast:
Dimmer:
Screen saver:
Timer:
To close this menu, place the cursor on
any one of the selectable items and press
the CANCEL
5.3.2 Sound settings
Sound settings such as the click beep are adjustable as follows.
■ ■
Procedure
1 .
1 .
1 .
Press the
MENU
hierarchical menus, select 7.3.2 Sound.
The screen as shown at right is displayed.
2 .
2 .
2 .
Move the cursor to the desired item and
press ENT. Then set the conditions as
appropriate with the numeric keypad or
jog dial, and press ENT again.
Notification level for a tone can be set
within 1 - 7.
When Sidetone is set to ON, an 800 Hz
tone sounds during keying in.
To close this menu, place the cursor on
any one of the selectable items and press
the CANCEL
5-4
key, and through
1 - 13
1 - 10
ON/OFF
1 - 999 seconds
key.
key, and through
key.
7.3.1)LCD adjustment
1.Contrast : 06
2.Dimmer
Maximum : 10
Typical : 08
Minimum : 06
3.Screen saver : OFF
Timer(sec): 060
0.Back
7.3.1)LCD adjustment
1.Contrast : 06
2.Dimmer
Maximum : 10
Typical : 08
Minimum : 06
3.Screen saver : OFF
Timer(sec): 060
0.Back
7.3.2)Sound
1.Operation
- Speaker : ON
- Click : ON
2.Notification level: 7
3.Sidetone : ON
0.Back
7.3.2)Sound
1.Operation
- Speaker : ON
- Click : ON
2.Notification level: 7
3.Sidetone : ON
0.Back