JRC JSS-2150 Instruction Manual page 77

(3) Setting user channels
A total of 20 groups with 20 channels set to each group (i.e. 400 channels) can be registered on
the equipment. This section explains how to set channels that are already registered.
■ ■
Procedure
1 .
1 .
1 .
Use the CH key to open the user channel
mode status display.
2 .
2 .
2 .
Pressing ENT causes the channel group
number to blink so a channel group can be
input.
Use the numeric keypad or jog dial to input the
number of a registered group.
When 2 is input using the numeric
Note
keypad, it appears on the far right
as shown in the screen on the right.
3 .
3 .
3 .
After inputting a group number, pressing ENT
causes the channel number to blink so a user
channel can be input.
Use the numeric keypad or jog dial to input the
number of a registered channel.
When 3 is input using the numeric
Note
keypad, it appears on the far right
as shown in the screen on the right.
4 .
4 .
4 .
Input the rest of the digits and press ENT.
The input user channel frequency is
displayed and the settings are complete.
The group name is displayed for 3 seconds
after the settings are done.
- Channels can be set directly in the status display by using the numeric keypad
Note
or the jog dial without setting a channel group. After inputting with the numeric
keypad, press ENT.
- See "5.4 Registering user channels" for how to register frequencies to user
channels.
- The user channel of the telex mode is set with the menu of the data terminal,
as Tune Frequency list.
I D 4 3 1 0 0 1 2 3 4 T I M E 2 3 : 5 9 ( U T C )
P o s 8 9 ﾟ 5 9 . 0 1 2 3 ' N
1 7 9 ﾟ 5 9 . 6 7 8 9 ' E @ 2 3 : 5 9
TEL U01- 001
4357.0
RX
4065.0
TX
S I G
W K R s c a n b a n d s :
2 4 6 8 1 2 1 6 ( M H z )
I D 4 3 1 0 0 1 2 3 4 T I M E 2 3 : 5 9 ( U T C )
P o s 8 9 ﾟ 5 9 . 0 1 2 3 ' N
1 7 9 ﾟ 5 9 . 6 7 8 9 ' E @ 2 3 : 5 9
TEL U20- 385
4146.0
RX
4146.0
TX
S I G
W K R s c a n b a n d s :
2 4 6 8 1 2 1 6 ( M H z )
Operation
( E X T )
kHz
kHz
( E X T )
kHz
kHz
4-27