Table of Contents
Advertisement
Adjustment
3.9.6
06 Paste Formation Finish Position Adjustment
Perform this adjustment for the position to finish equalizing the paste applied on the body set.
To specify Paste Formation Finish Position Adjustment
1
Touch [Adjustment] on the Machine Status Screen.
The Adjustment Menu Screen will be displayed.
2
Touch [04 Finisher Adjustment], [08 Perfect Binder Adjustment], and then [06
PasteFormationFinishPos.].
The Paste Formation Finish Position Adjustment Screen will be displayed.
3
Display the required size key using up/down arrow keys to select the paper size of the body set to be
attached with the cover.
4
Touch [COPY] tab.
The Copy Screen will be displayed.
5
Select the PB tray or desired main body tray, then press [Start].
A sample pattern of perfect-bound book will be output.
6
Check that the pasting on the body set finishes to be equalized in proper position.
7
If the desired result cannot be obtained, touch [ADJUSTMENT] tab.
8
Touch [+ <--> -] to specify the value to be positive or negative. Use the touch panel keypad to enter the
desired adjustment value, then touch [<<SET].
Available range: -128 (early) to +127 (late), 1 step = 0.1 mm
9
Repeat the adjustment steps from 3 to 8 until the desired result is obtained.
10
Touch [Return] to restore the Perfect Binder Adjustment Menu Screen.
CS665 Pro
3
3-75
Advertisement
Table of Contents
