Suzuki DL650K5 Service Manual page 535

"C29" (P1654-H/L) STP SENSOR CIRCUIT MALFUNCTION
DETECTED CONDITION
C29 Signal voltage is not within the following
(P1654) range.
Difference between actual throttle open-
ing and opening calculated by ECM is
larger than specified value.
0.1 V < Sensor voltage < 4.88 V
P1654 Sensor voltage is higher than specified
H
value.
Sensor voltage is lower than specified
L
value.
STP sensor
INSPECTION
NOTE:
After repairing the trouble, clear the DTC using SDS tool.
Step 1
1) Turn the ignition switch OFF.
2) Lift and support the fuel tank. (!DL650K4 5-7)
3) Check the STP sensor coupler for loose or poor contacts.
If OK, then measure the STP sensor input voltage.
4) Disconnect the STP sensor coupler.
5) Turn the ignition switch ON.
6) Measure the voltage at the Red wire A and ground.
7) Also, measure the voltage at the Red wire A and B/Br wire B.
$ STP sensor input voltage: 4.5 – 5.5 V
# 09900-25008: Multi-circuit tester set
' Tester knob indication: Voltage (()
Is the voltage OK?
YES Go to Step 2.
• Loose or poor contacts on the ECM coupler
(Terminal 5 or B).)
NO
• Open or short circuit in the R wire or B/Br wire.
• STP sensor maladjusted.
• STP sensor circuit open or short.
• STP sensor malfunction.
• ECM malfunction.
• STP sensor circuit shorted to VCC or ground cir-
cuit open.
• STP sensor circuit open or shorted to ground or
VCC circuit open.
R
Y
B/Br
(+ Red – - Ground)
(+ Red – - B/Br)
DL650K7/AK7 ('07-MODEL)
POSSIBLE CAUSE
ECM
VCC
STP
E2
1
1
13-31
V