Suzuki DL650K5 Service Manual page 138

3-84 ENGINE
• When securing the right and left crankcase halves, tighten
each bolt a little at a time to equalize the pressure. Tighten all
the securing bolts to the specified torque values.
$ Crankcase bolt: (M8) 26 N·m (2.6 kgf-m, 19.0 lb-ft)
(M6) 11 N·m (1.1 kgf-m, 8.0 lb-ft)
#
Do not drop the O-ring into the crankcase when
assembling the right and left crankcase halves.
NOTE:
* After the crankcase bolts have been tightened, check if the
crankshaft, the driveshaft and the countershaft rotate
smoothly.
* Fit the clamp to the bolt C as shown.
OIL PLATE
• Install the oil plate 1 and the oil plate bolts tighten to the
specified torque.
$ Oil plate bolt: 10 N·m (1.0 kgf-m, 7.0 lb-ft)
ENGINE SPROCKET SPACER
• Install the new O-ring 1 into the engine sprocket spacer 2.
#
Use the new O-ring to prevent oil leakage.
• Install the engine sprocket spacer 2.
NOTE:
* The grooved A side of the engine sprocket spacer 1 must
face crankcase side.
* Apply SUZUKI SUPER GREASE to the oil seal lip and O-ring.
' 99000-25030: SUZUKI SUPER GREASE "A" (USA)
99000-25010: SUZUKI SUPER GREASE "A" (Others)