Suzuki DL650K5 Service Manual page 118

3-64 ENGINE
• Tighten the special tool bolts to the specified torque.
$ Special tool bolt: 23 N·m (2.3 kgf-m, 16.5 lb-ft)
#
Before installing the bearings, lightly shave off the
sharp edge part A of the crankcase chamfer by using
an oilstone and wash the crankcase bore with enough
engine oil.
• Set the bearings installed in the special tool to the crankcase
half as shown.
#
* Be sure the bearing protruded side B faces the
crankcase bore.
* Align the bearing/special tool mating surface with
the line C on the crankcase.
NOTE:
Install the bearing from inside to outside of each crankcase
halves.