Suzuki DL650K5 Service Manual page 109

CONROD-CRANK PIN BEARING SELECTION
• Place the plastigauge axially along the crank pin, avoiding the
oil hole, at TDC or BDC side as shown.
" 09900-22301: Plastigauge
09900-22302: Plastigauge
• Tighten the conrod cap bolts to the specified torque, in two
stages. (!3-57)
#
Never rotate the crankshaft or conrod when a piece of
plastigauge is installed.
• Remove the bearing caps and measure the width of the com-
pressed plastigauge using the envelope scale. This measure-
ment should be taken at the widest part of the compressed
plastigauge.
& Conrod big end oil clearance
Standard: 0.032 – 0.056 mm (0.0013 – 0.0022 in)
Service Limit: 0.080 mm (0.0031 in)
• If the oil clearance exceeds the service limit, select the speci-
fied bearings from the bearing selection table.
• Check the corresponding conrod I.D. code numbers ("1" or
"2") A.
• Check the corresponding crank pin O.D. code numbers ("1",
"2" or "3") B.
Bearing selection table
Code
Conrod 1
I.D. A
2
Crank pin O.D. B
1 2
Green Black
Black Brown
3
Brown
Yellow
ENGINE 3-55