Suzuki DL650K5 Service Manual page 140

3-86 ENGINE
GENERATOR ROTOR
• Install the starter driven gear 1.
• Apply engine oil to the bushing of the starter driven gear.
• Degrease the tapered portions A of the generator rotor
assembly and the crankshaft. Use nonflammable cleaning
solvent to wipe off oily or greasy matter and make these sur-
faces completely dry.
• Fit the key 2 in the key slot on the crankshaft completely.
• Install the generator rotor assembly onto the crankshaft.
• While holding the generator rotor with the special tool, tighten
its bolt to the specified torque.
" 09930-44530: Rotor holder
$ Generator rotor bolt: 120 N·m (12.0 kgf-m, 87 lb-ft)
CAM CHAIN DRIVE SPROCKET
• Install the cam chain drive sprocket 1 onto the crankshaft.
NOTE:
* Align the punched mark A on the cam chain drive sprocket
with the punched mark B on the crankshaft.
* Apply MOLYBDENUM OIL SOLUTION to the cam chain drive
sprocket.
* MOLYBDENUM OIL SOLUTION