Suzuki DL650K5 Service Manual page 384

8-22 ELECTRICAL SYSTEM
SIDE-STAND RELAY INSPECTION
First check the insulation between D and E terminals with the
tester. Then apply 12 V to terminals D and C (+ to D and - to
C) and check the continuity between D and E. If there is no
continuity, replace the turn signal/side-stand relay with a new
one.
# 09900-25008: Multi circuit tester set
+ Tester knob indication: Continuity test (,)
DIODE INSPECTION
Measure the voltage between the terminals using the multi cir-
cuit tester. Refer to the following table.
C, B
A
# 09900-25008: Multi circuit tester set
) Tester knob indication: Diode test (*)
NOTE:
If the multi circuit tester reads 1.4 V and below when the tester
probes are not connected, replace its battery.
1 Diode
2 Side-stand relay
3 Turn signal relay
+ Probe of tester to:
C, B
1.4 V and more
0.4 – 0.6
Unit: V
A