Quick Install - Ricoh C2408 Operating Instructions Manual

Installing the Printer Driver and Software

Quick Install

Auto Run will start the installer automatically when you load the CD-ROM in
the CD-ROM drive. By selecting Quick Install, you can easily install the PCL 5c
printer driver and the RPCS™ printer driver. The SmartNetMonitor for Client
can also be installed provided the machine and the computer are connected via
the network.
2
The following conditions are required:
• Windows 95/98/Me, Windows 2000/XP or Windows NT 4.0
For Ethernet connections:
• The machine must be connected to the network using an Ethernet cable.
• TCP/IP protocol must be configured.
• The IP address must be assigned to both machine and computer.
For parallel connections:
• The machine must be connected to the computer using a parallel cable.
• Bidirectional transmission must be enabled.
Limitation
❒ If your operating system is Windows 2000/XP or Windows NT 4.0, installing
a printer driver using Auto Run requires Administrators permission. When
you install a printer driver using Auto Run, log on using an account that has
Administrators permission.
❒ When the machine is connected to the computer using the IEEE 1394 inter-
face, Quick Install cannot be used. See p.43 "Installing the Printer Driver Us-
ing IEEE 1394".
Important
❒ If your system is Windows NT 4.0, we recommend that you upgrade the Win-
dows NT 4.0 operating system to Service Pack 4 or later before installing the
PCL 5c or RPCS™ printer drivers. Contact your Windows retailer for more in-
formation about the latest version available.
Note
❒ If you want to cancel Auto Run, hold down the { { { { SHIFT} } } } key (when your op-
erating system is Windows 2000/XP, hold down the left { { { { SHIFT} } } } key) while
inserting the CD-ROM. Keep the { { { { SHIFT} } } } key held down until the computer
has finished accessing the CD-ROM.
24