Using A Program - Ricoh C2408 Operating Instructions Manual

Simplifying the Operation
D Enter the time to send.
Note
❒ If "Send Later" is already
specified, that time is shown.
Press the { { { { Clear Modes} } } } key to
change "Send Later".
B B B B
Press the { { { { Program} } } } key.
The program (Fax) is shown.
C C C C
Select a program number in which
"*Not Programed" is shown.
6
Note
❒ If you make a mistake, press
[Cancel] and select a program
number again.
❒ When you change a Keystroke
Program, press [Store] after
pressing the program number
you want to change. If you
make a mistake, press [Do not
Store] and return to step
D D D D
Enter the program name, and then
press [OK].
The program has been registered.
Note
❒ If you make a mistake, press
[Backspace] or [Delete All] and try
again.
❒ You should register the pro-
gram name.
82
E E E E
Press [Exit].
The initial display is shown.

Using a program

Example of executing a program
using Send Later with the fax
number "0123456789".
A A A A
Make sure that the machine is in
Facsimile mode and the standby
display is shown.
Note
❒ If the standby display is not
shown, press the { { { { Facsimile} } } }
key.
B B B B
Place your original.
Note
❒ If you have not a registered des-
tinations or scan settings as a
program, enter the fax number
for the destination and select
any scan settings you require.
C C C C
Press the { { { { Program} } } } key.
D D D D
Select a program number you reg-
istered.
The initial display is shown.
Then, the registered fax number
and time are shown. Transmission
C
.
Mode is selected.
E E E E
Press the { { { { Start} } } } key.
The fax number and specified time
are shown on the display and the
machine starts to scan the original.