Ricoh C2408 Operating Instructions Manual page 327

B B B B
Adjust the paper guides to the paper size.
Important
❒ If the paper guides are not flush against the paper, skewed images or paper
misfeeds might occur.
C C C C
Gently insert the paper face down in the bypass tray until the beeper sounds.
1.
Extender
2.
Paper guides
Note
❒ The beeper will not sound if it is turned off. Gently insert the paper until it
stops.
❒ Do not stack paper over the limit mark, otherwise a skewed image or paper
misfeeds might occur.
❒ Open out the extender to support paper sizes larger than A4 L, 8
❒ Fan the paper to get air between the sheets to avoid a multi-sheet feed.
❒ When setting an OHP transparency, make sure that its front and back sides
are properly positioned.
❒ Select the paper type when printing on OHP transparencies or thick paper
(over 105g/m
encies".
D D D D
Select the paper size.
Note
❒ You can set paper size using the printer driver. The following procedures
are not necessary when setting paper size using the printer driver.
❒ The paper size set using the printer driver has priority over that set using
the display panel.
❒ When the printer driver is not used, make settings using the display panel.
Reference
For printer driver settings, see the printer driver's Help.
For setting custom sizes, see p.17 "Setting custom size paper"
1
2
ZGPH110E
2
). For details, see p.18 "Setting thick paper or OHP transpar-
Setting Paper on the Bypass Tray
"×11" L.
1
/
2
1
15