Service Call Error; Error Code - Epson AcuLaser C9200N Service Manual

EPSON AcuLaser C9200N

3.3 Service Call Error

3.3.1 Error code

The CPU performs a self-diagnostics function. If a malfunction is detected, an error code is displayed on the Control Panel.
ERROR CODE LIST
Engine-related Error
Code Item
E100
Polygon Motor/C failure to turn
E101
Polygon Motor/M failure to turn
E102
Polygon Motor/Y failure to turn
E103 Polygon Motor/K failure to turn
E110 Laser malfunction (Cyan)
E111
Laser malfunction (Magenta)
E112
Laser malfunction (Yellow)
E113
Laser malfunction (Black)
E200
Transfer Belt Separation
E210
2nd Transfer Roller Separation
E220
Transfer Belt Unit New Article Release
Troubleshooting
Table 3-16. Error Code List
The Polygon motor fails to turn stably even after the lapse of a given period of time after activating the
Polygon motor.
Motor Lock signal detects H for a given period time consecutively during the Polygon motor is rotating.
SOS signal is not detected within the lapse of a given period of time after staring the laser output.
SOS signal is not detected within a given period of time during printing or IDC sensor adjustment.
The 1st Image Transfer Pressure/Retraction Position Sensor doesn't turn ON (Retracting) even after the
lapse of a given period of time after the 1st Image Transfer Pressure/Retraction Clutch has turned ON during
the Transfer Belt is retracting.
The 1st Image Transfer Pressure/Retraction Position Sensor doesn't turn OFF (Pressuring) even after the
lapse of a given period of time after the 1st Image Transfer Pressure/Retraction Clutch has turned ON during
the Transfer Belt is pressuring.
The 2nd Image Transfer Pressure Position Sensor doesn't turn ON (Retracting) even after the lapse of a
given period of time after the 2nd Image Transfer Pressure/Retraction Motor has started rotating during the
2nd Transfer Roller is retracting.
The 2nd Image Transfer Pressure Position Sensor doesn't turn OFF (Pressuring) even after the lapse of a
given period of time after the 2nd Image Transfer Pressure/Retraction Motor has started rotating during the
2nd Transfer Roller is pressuring.
A new installation is not detected when a new Transfer Belt Unit is installed.
Service Call Error
Detection Timing
Revision D
Reference
p.113
p.113
p.114
p.114
p.114
107
Confidential