Epson AcuLaser C9200N Service Manual page 192

EPSON AcuLaser C9200N
[9]
7. Install the Photoconductor Unit Guide Rail [9].
Make sure that the two Claws [10] at rear end of the rail are fit in the locating hole on
the Main Unit.
8. Reinstall the Transfer Belt Unit.
9. Reinstall the Front Door.
10.Make skew adjustment of the PH Unit.
When installing the PH Unit, make sure to conduct PH Unit skew adjustment
A D J U S T M E N T
R E Q U I R E D
regardless of whether the Unit is new or not.
(p313))
DISASSEMBLY AND ASSEMBLY
[10]
[9]
4038F2C117DA
(Refer to Chapter 5 "ADJUSTMENT")
Main Unit Disassembly/Reassembly
Revision D
192
Confidential