Epson AcuLaser C9200N Service Manual page 333

EPSON AcuLaser C9200N
PH window
1. Open the Front Door.
2. Remove the PH window cleaning jig.
3. Insert the PH window cleaning jig to the cleaning port and clean it by putting
the jig back and forth a couple times.
Clean every PH window of YMCK.
Cleaning jig
Cleaning port
Cleaning jig
Figure 6-2. Cleaning the PH window
MAINTENANCE
4038F2C547DA
4038F2C548DA
Cleaning
Transfer belt
Using a dried soft cloth, wipe the Transfer belt.
If it is difficult to clean with dried soft cloth, dampen a soft cloth
with a solvent.
Do not wipe out with water.
When solvent is used to dampen a cloth, do not use the ones
other than shown below:
Isopropyl alcohol, Ethyl alcohol, PPC Cleaner, Sol mix AP-7.
Figure 6-3. Cleaning the Transfer belt
Registration roller
Using a soft cloth dampened with alcohol, wipe the registration roller.
Registration roller
Figure 6-4. Cleaning the Registration roller
Revision D
333
Confidential