Epson AcuLaser C9200N Service Manual page 84

EPSON AcuLaser C9200N
Type Unit Status
Periodic Fusing Unit Near- Condition becomes Near-Empty when any of the
following values reaches the given value.
Empty
replacement
• Number of prints (Paper more than 216 mm in
parts
• Value of the hours which the Fusing Motor has
Near- Condition becomes Empty 2 when any of the
Empty 2 following values reaches the given value.
• Number of prints (Paper more than 216 mm in
• Value of the hours which the Fusing Motor has
Empty Condition becomes Empty when the print job is
received in the condition of Near-Empty 2
Empty 2 Condition becomes Empty 2 when number of
prints reach the given numbers to print.
Transfer Belt Near- Condition becomes Near-Empty when the hours
Unit Empty which the Transfer Belt has turned reached the
given time.
Near- Condition becomes Near-Empty 2 when the
hours which the Transfer Belt has turned reached
Empty 2
the given time.
Empty Condition becomes Empty when the print job is
received in the condition of Near-Empty 2
Maintenance Unit/ Near- Condition becomes Near-Empty when number of
prints reach the given value (count is paper-size
Feed Roller/ Empty
independent).
Separation Roller
Empty Condition becomes Empty when number of prints
reach the given value (count is paper-size
independent).
Note * : Continuing on printing is available until the power is turned OFF. When the Power is turned ON again, the status will become Near-Empty.
OPERATING PRINCIPLES
Life detection
Sub Scan Direction is two counts)
turned is converted into the number of prints
Sub Scan Direction is two counts)
turned converted into the number of prints
Operating Principle of Main Unit Mechanism
Panel display
Parts attributed
Error
life
Message
LED
Fusing Motor Fuser Needed --- Prepare a new unit
Soon
Replace Fuser --- Change to Empty
condition by receiving
job.
Flash • Continue on printing
--- Replace Fuser
by pushing down
[Start/Stop] to disable
the error
• Replace with a new unit
--- Replace Fuser Light Replace with a new unit Not
Main Motor Transfer Unit --- Prepare a new unit
Needed Soon
Replace Transfer --- Change to Empty
condition by receiving
Unit
job.
Flash • Continue on printing
--- Replace Transfer
by pushing down
Unit
[Start/Stop] to disable
the error.
• Replace with a new unit
Feed Roller/ Replace --- Prepare a new unit
Maintenance
Separation Roller
Unit/Replace
Feed Roller xx
Flash • Continue on printing
Replace
by pushing down
Maintenance
[Start/Stop] to disable
Unit/Replace
the error.
Feed Roller xx
• Replace with a new unit
continued
Image
New unit detection
Solution on
(Reset counter)
quality
printing
Available Warranty When Fuse for new
unit detection is
conducted, unit is
judged as new unit
and counter is reset
automatically.
--- ---
Available Out of
warranty
* .
---
Available
Available Warranty When Fuse for new
unit detection is
conducted, unit is
judged as new unit
--- ---
and counter is reset
automatically.
Available Out of
warranty
Available Warranty Reset the counter
manually from
Maintenance Menu.
Available Out of
warranty
Revision D
Dictate Unit
Detection for
connector
connection
1st Image
Transfer
Pressure
Retraction
Sensor
None
84
Confidential