Writing Usb Id - Epson AcuLaser C9200N Service Manual

EPSON AcuLaser C9200N

5.2.4 Writing USB ID

PURPOSE
This printer includes USB interface as standard. A unique USB ID has been assigned to
each printer to be identified by a host PC connected via the USB interface. The USB ID
information is stored on the nonvolatile memory on the Main Board. Therefore,
whenever the Main Board is replaced, the ID must be written to the new board. As for
this product, the model ID information is stored, it must also be written to the board.
REQUIRED TOOL
The program to be used for writing the USB-ID and the required operating
environment are as follows.
Program name
EPSON Page Printer Main Board Initialization Tool
Operating environment
SO
Windows95/OSR2.0 or later, Windows98, Windows Me, Windows
2000, Windows UP
Interface to be used
USB
ADJUSTMENT
INSTALLING THE PROGRAM & BASIC OPERATION
1. Copy a set of files of "Main Board initial setting tool" to a folder created on the
PC.
The set of files of "Main Board initial setting tool" must be stored in
C H E C K
P O I N T
one folder.
2. Double click on the program icon [
model name in the [Model Selection].
3. In the [Port Selection], select the port connected to the printer.
The "Auto selection" allows you to search printers connected to the
C H E C K
P O I N T
PC, and establish a connection with the first detected printer. When
multiple printers are connected, however, specify the port name
rather than using the "Auto selection" since a printer detected by
the auto detection varies according to the communication status.
Adjustment
] to start up the program, and select the
Figure 5-4. Basic Operation
Revision D
318
Confidential