Suzuki GSX1300BK B-King Service Manual page 480

14) Remove the swingarm pivot shaft.
15) Remove the swingarm.
16) Remove the cushion rods (7).
7
17) Remove the rear fender (lower) (8), chain case (9)
and chain buffer (10) from the swingarm.
10
18) Remove the plate (11).
11
Installation
Install the swingarm in the reverse order of removal. Pay
attention to the following points:
• Temporarily install the cushion rod mounting nut.
I823H1230023-02
8
• Adjust swingarm pivot thrust clearance in the following
9
I823H1230024-01
I823H1230025-01
NOTE
The stamped marks "A" on the cushion rod
should be face out side.
procedures:
– Insert the swingarm pivot shaft and tighten it to the
specified torque.
Special tool
(A): 09944–28320 (Hexagon socket (19
mm))
Tightening torque
Swingarm pivot shaft: 15 N·m (1.5 kgf-m, 11.0
lb-ft)
Rear Suspension: 2C-9
"A"
I823H1230026-02
(A)
I823H1230027-01