Starter Motor Removal And Installation; Starter Motor Disassembly And Assembly - Suzuki GSX1300BK B-King Service Manual

1I-4 Starting System:

Starter Motor Removal and Installation

Removal
1) Turn the ignition switch OFF and disconnect the
battery (–) lead wire. Refer to "Battery Removal and
Installation in Section 1J (Page 1J-14)".
2) Remove the throttle body. Refer to "Throttle Body
Removal and Installation in Section 1D (Page 1D-
10)".
3) Disconnect the starter motor lead wire (1).
4) Remove the starter motor (2).
2
Installation
Install the starter motor in the reverse order of removal.
Pay attention to the following points:
• Apply grease to the O-ring.
: Grease 99000–25010 (SUZUKI SUPER
GREASE A or equivalent)
CAUTION
!
Replace the O-ring with a new one.
• Install the starter motor. Refer to "Wiring Harness
Routing Diagram in Section 9A (Page 9A-5)".

Starter Motor Disassembly and Assembly

B823H11906002
Refer to "Starter Motor Removal and Installation
(Page 1I-4)".
Disassembly
Disassemble the starter motor as shown in the starter
motor components diagram. Refer to "Starter Motor
Components (Page 1I-3)".
Assembly
Reassemble the starter motor in the reverse order of
removal. Pay attention to the following points:
Replace the O-rings with new ones to prevent
1
oil leakage and moisture.
• Apply grease to the lip of the oil seal.
GREASE A or equivalent)
I823H1190038-01
• Apply grease to the bearing.
GREASE A or equivalent)
I823H1190039-01
• Align the match marks on the starter motor case with
the match mark on each housing end.
CAUTION
!
: Grease 99000–25010 (SUZUKI SUPER
: Grease 99000–25010 (SUZUKI SUPER
B823H11906003
I823H1190003-01
I823H1190004-02