Section - Suzuki GSX1300BK B-King Service Manual

00-3 Precautions:
• Check the male connector for bend and female
connector for excessive opening. Also check the
coupler for locking (looseness), corrosion, dust, etc.
4
"A"
3. Coupler 4. Probe
Clamp
• Clamp the wire harness at such positions as indicated
in "Wiring Harness Routing Diagram in Section 9A
(Page 9A-5)".
• Bend the clamp properly so that the wire harness is
clamped securely.
• In clamping the wire harness, use care not to allow it
to hang down.
• Do not use wire or any other substitute for the band
type clamp.
CORRECT
Fuse
• When a fuse is blown, always investigate the cause to
correct it and then replace the fuse.
• Do not use a fuse of different capacity.
• Do not use wire or any other substitute for the fuse.
3
4
I649G1000030-02
"A": Where male terminal fits
INCORRECT
I718H1000001-02
I649G1000001-02
Switch
Never apply grease material to switch contact points to
prevent damage.
ECM / Various sensors
• Since each component is a high-precision part, great
care should be taken not to apply any severe impacts
during removal and installation.
• Be careful not to touch the electrical terminals of the
electronic parts (ECM, etc.). The static electricity from
your body may damage them.
• When disconnecting and connecting the coupler,
make sure to turn OFF the ignition switch, or
electronic parts may get damaged.
1. Ignition switch
I310G1000007-01
I310G1000008-01
1
I823H1000001-02