Engine Top Side Disassembly - Suzuki GSX1300BK B-King Service Manual

4. Nut
: 55 N m (5.5 kgf-m, 40.0 lb-ft)
• Install the engine sprocket. Refer to "Engine Sprocket
Removal and Installation in Section 3A (Page 3A-2)".
• Install the exhaust pipe assembly and muffler. Refer to
"Muffler / Muffler Joint / Exhaust Pipe Removal and
Installation in Section 1K (Page 1K-12)".
• Install the radiator. Refer to "Radiator / Cooling Fan
Motor Removal and Installation in Section 1F
(Page 1F-6)".
• Install the throttle body. Refer to "Throttle Body
Removal and Installation (Page 1D-10)".
• Install the air cleaner box. Refer to "Air Cleaner Box
Removal and Installation (Page 1D-6)".
• After remounting the engine, route the wiring harness,
cable and hoses properly. Refer to "Wiring Harness
Routing Diagram in Section 9A (Page 9A-5)", "Throttle
Cable Routing Diagram (Page 1D-2)" and "Water
Hose Routing Diagram in Section 1F (Page 1F-3)".
• Pour engine coolant and engine oil. Refer to "Cooling
System Inspection in Section 0B (Page 0B-13)" and
"Engine Oil and Filter Replacement in Section 0B
(Page 0B-10)".
• Pour engine oil. Refer to "Engine Oil and Filter
Replacement in Section 0B (Page 0B-10)".
• After finishing the engine installation, check the
following items.
– Throttle cable play
Refer to "Throttle Cable Play Inspection and
Adjustment in Section 0B (Page 0B-12)".
– Throttle valve synchronization
Refer to "Throttle Valve Synchronization (Page 1D-
16)".
– Drive chain slack
Refer to "Drive Chain Inspection and Adjustment in
Section 0B (Page 0B-15)".
– Engine oil and coolant leakage
Refer to "Cooling Circuit Inspection in Section 1F
(Page 1F-4)".

Engine Top Side Disassembly

It is unnecessary to remove the engine assembly from
the frame when servicing the cylinder head cover and
camshafts.
: 45 N m (4.5 kgf-m, 32.5 lb-ft)
"a": 45 mm (1.77 in)
Cylinder Head Cover
Remove the cylinder head cover (1) and its gaskets.
Camshafts
1) Remove the spark plugs. Refer to "Ignition Coil /
2) Remove the valve timing inspection cap (1) and
B823H11406016
Engine Mechanical:
"e": 37.5 mm (1.48 in)
"f": 243 mm (9.56 in)
NOTE
Before servicing the engine top side
components (until camshafts removal) with
the engine inplace, remove the following
parts:
• Air cleaner box
• Throttle body
Except for these "Engine Top Side
Components" can not be serviced with the
engine installed in the frame. Refer to
"Engine Assembly Removal (Page 1D-19)"
and "Engine Assembly Installation (Page 1D-
25)" .
CAUTION
!
Identify the position of each removed part.
Organize the parts in their respective groups
(e.g., intake, exhaust) so that they can be
reinstalled in their original positions.
Plug Cap and Spark Plug Removal and Installation in
Section 1H (Page 1H-6)".
starter clutch cover cap (2).
1D-28
1
I823H1140312-01
1
2
I823H1140313-01