Suzuki GSX1300BK B-King Service Manual page 406

9) Remove the ignition switch (7).
Installation
Install the ignition switch in the reverse order of removal.
Pay attention to the following points:
• Tighten the ignition switch mounting bolts (1) to the
specified torque with the special tools.
Special tool
(A): 09930–11920 (Torx bit (JT40H))
(B): 09930–11940 (Bit holder)
Tightening torque
Ignition switch mounting bolt (a): 6 N·m (0.6 kgf-
m, 4.5 lb-ft)
7
I823H1180021-01
(B)
(A)
1
(a)
I823H1180022-01
• Route the throttle cable.
• Tighten the steering damper mounting bolts (2) to the
specified torque. Refer to "Steering Damper
Construction in Section 6B (Page 6B-6)".
Tightening torque
Steering damper mounting bolt (b): 23 N·m (2.3
kgf-m, 16.5 lb-ft)
2
(b)
Ignition System: 1H-13
I823H1180023-01
I823H1180024-01