Fuel Mesh Filter Inspection And Cleaning; Fuel Injector / Fuel Delivery Pipe / T-Joint Removal And Installation; Fuel Injector Inspection And Cleaning - Suzuki GSX1300BK B-King Service Manual

1G-15 Fuel System:
• When installing the fuel pump assembly, first tighten
all the fuel pump mounting bolts lightly and then to the
specified torque, in the ascending of numbers.
Tightening torque
Fuel pump mounting bolt (a): 10 N·m (1.0 kgf-m,
7.0 lb-ft)
(5)
(2)

Fuel Mesh Filter Inspection and Cleaning

Inspect the fuel mesh filter in the following procedures:
1) Remove the fuel mesh filter. Refer to "Fuel Pump
Disassembly and Assembly (Page 1G-13)".
2) If the fuel mesh filter is clogged with foreign particles,
it hinders smooth gasoline flow resulting in loss of
engine power. Such a filter should be cleaned by
blowing with compressed air.
NOTE
When the fuel mesh filter is dirtied
excessively, replace the fuel filter cartridge
with a new one.
3) After finishing the fuel mesh filter inspection, reinstall
the fuel mesh filter. Refer to "Fuel Pump
Disassembly and Assembly (Page 1G-13)".
(3)
(1)
(a)
(4)
I823H1170024-05
B823H11706014
I823H1170025-01
Fuel Injector / Fuel Delivery Pipe / T-joint
Removal and Installation
Refer to "Throttle Body Disassembly and Assembly in
Section 1D (Page 1D-12)".

Fuel Injector Inspection and Cleaning

Inspect the fuel injector in the following procedures:
1) Remove the fuel injector. Refer to "Throttle Body
Disassembly and Assembly in Section 1D (Page 1D-
12)".
2) Check the fuel injector filter for evidence of dirt and
contamination. If present, clean and check for
presence of dirt in the fuel lines and fuel tank.
3) Install the fuel injector. Refer to "Throttle Body
Disassembly and Assembly in Section 1D (Page 1D-
12)".
B823H11706015
B823H11706016
I823H1170026-01