Cooling Fan Relay Inspection; Ect Sensor Removal And Installation; Ect Sensor Inspection; Thermostat Cover / Thermostat Removal And Installation - Suzuki GSX1300BK B-King Service Manual

1F-10 Engine Cooling System:

Cooling Fan Relay Inspection

Inspect the fan relay in the following procedures:
1) Remove the seat. Refer to "Exterior Parts Removal
and Installation in Section 9D (Page 9D-14)".
2) Remove the cooling fan relay (1).
3) First check the insulation between "A" and "B"
terminals with tester. Then apply 12 volts to "C" and
"D" terminals, (+) to "C" and (–) to "D", and check the
continuity between "A" and "B".
If there is no continuity, replace it with a new one.
Special tool
: 09900–25008 (Multi-circuit tester set)
Tester knob indication set
Continuity test (
"A"
"B"
4) Reinstall the removed parts.

ECT Sensor Removal and Installation

Refer to "ECT Sensor Removal and Installation in
Section 1C (Page 1C-5)".

ECT Sensor Inspection

Refer to "ECT Sensor Inspection in Section 1C
(Page 1C-5)".
B823H11606010
1
I823H1160021-01
)
"C"
"D"
I718H1160006-03
B823H11606011
B823H11606012
Thermostat Cover / Thermostat Removal and
Installation
Removal
1) Drain a small amount of engine coolant. Refer to
"Cooling System Inspection in Section 0B (Page 0B-
13)".
2) Lift and support the fuel tank. Refer to "Fuel Tank
Removal and Installation in Section 1G (Page 1G-
10)".
3) Disconnect the water air bleed hose (1) and cylinder
head outlet hose (2).
4) After removing of the thermostat cover bolts (3),
remove the thermostat cover (4).
4
5) Remove the thermostat (5).
B823H11606013
1
2
I823H1160022-01
3
I823H1160023-01
5
I823H1160024-01