Suzuki GSX1300BK B-King Service Manual page 41

0B-11 Maintenance and Lubrication:
3) Tighten the oil drain plug (1) to the specified torque.
CAUTION
!
Replace the gasket washer with a new one.
Tightening torque
Oil drain plug (a): 23 N·m (2.3 kgf-m, 16.5 lb-ft)
1
(a)
4) Pour new oil through the oil filler. When performing
an oil change (without oil filter replacement), the
engine will hold about 3.1 L (3.3/2.7 US/lmp qt) of oil.
Use of SF/SG or SH/SJ in API with MA in JASO.
5) Start up the engine and allow it to run for several
minutes at idling speed.
6) Turn off the engine and wait about three minutes.
7) Hold the motorcycle vertically and check the oil level
through the inspection window (3). If the oil level is
below the "L" mark, add oil to the "F" mark. If the
level is above the "F" mark, drain the oil until the
level reaches the "F" mark.
F
L
Oil Level Inspection
1) Place the motorcycle on the side-stand.
2) Start up the engine and allow it to run for several
minutes at idle speed.
I823H1020023-02
3
I823H1020024-02
3) Turn off the engine and wait about three minutes.
4) Hold the motorcycle vertically and check the oil level
through the inspection window (1). If the level is
below mark "L", add oil to "F" level. If the level is
above mark "F", drain oil to "F" level.
F
L
Oil Filter Replacement
1) Drain engine oil as described in the engine oil
replacement procedure.
2) Remove the bolt (1). Pull the under cover downward.
1
3) Remove the oil filter (2) using the special tool.
Special tool
(A): 09915–40610 (Oil filter wrench)
4) Apply engine oil lightly to the O-ring of new oil filter,
before installation.
CAUTION
!
ONLY USE A GENUINE SUZUKI
MOTORCYCLE OIL FILTER.
Other manufacturer's oil filters may differ in
thread specifications (thread diameter and
pitch), filtering performance and durability
which may lead to engine damage or oil
leaks. Also, do not use a genuine Suzuki
automobile oil filter on this motorcycle.
1
I823H1020026-02
I823H1020027-02
(A)
2
I823H1020028-01