Water Pump Components - Suzuki GSX1300BK B-King Service Manual

1F-12 Engine Cooling System:
6) Read the thermometer just when opening the
thermostat. If this reading, which is the temperature
level at which the thermostat valve begins to open, is
out of the standard value, replace the thermostat
with a new one.
Thermostat valve opening temperature
Standard: Approx. 82 C (180 F)
7) Keep on heating the water to raise its temperature.

Water pump Components

1. Water pump case
2. O-ring
3. Impeller
4. Mechanical seal
5. Oil seal
2
5
4
: 8 N m (0.8 kgf-n, 6.0 Ib-ft)
: 6 N m (0.6 kgf-n, 4.5 Ib-ft)
: 10 N m (1.0 kgf-n, 7.0 Ib-ft)
: Apply grease.
: Apply engine coolant.
8) Just when the water temperature reaches specified
value, the thermostat valve should have been lifted
by at least 8 mm (0.31 in). A thermostat failing to
satisfy either of the two requirements (start-to-open
temperature and valve lift) must be replaced.
Thermostat valve lift "a"
Standard: Over 8 mm (0.31 in) and at 95 C (203
F)
9) Install the thermostat. Refer to "Thermostat Cover /
Thermostat Removal and Installation (Page 1F-10)".
2
(a)
: Apply molybudenum oil solution.
: Apply thread lock.
: Do not reuse.
I705H1160031-04
B823H11606015
(c)
1
(b)
I823H1160058-03