Excv Cable Removal And Installation - Suzuki GSX1300BK B-King Service Manual

CAUTION
!
Replace the gaskets, connectors and O-rings with new ones when reassembling.

EXCV Cable Removal and Installation

Removal
1) Turn the ignition switch OFF.
2) Lift and support the fuel tank. Refer to "Fuel Tank
Removal and Installation in Section 1G (Page 1G-
10)".
3) Connect the special tool (Mode select switch) to the
dealer mode coupler. Refer to "Self-Diagnostic
Procedures in Section 1A (Page 1A-12)".
4) After turning the mode select switch ON, turn the
ignition switch ON.
Special tool
(A): 09930–82720 (Mode select switch)
5) Check that the cable slots of the EXCVA pulley
comes to the middle (Adjustment position) "A".
6) Turn the ignition switch OFF.
CAUTION
!
Before removing the EXCV cables, be sure to
set the EXCVA pulley to the adjustment
position.
B823H11B06008
(A)
I823H11B0003-01
"A"
I823H11B0004-01
7) Remove the EXCV cover.
8) Remove the EXCV cable bracket (1) by removing
the nut (2).
9) Disconnect the EXCV cables (3) from the EXCV
pulley (4).
1
4
10) Remove the EXCV cables from the EXCVA pulley
(5).
Exhaust System: 1K-5
I823H11B0005-01
2
3
I823H11B0006-01
5
I823H11B0007-03