Servo Monitor ／ Servo Test; Servo - FUTABA 6k Instruction Manual

Servo monitor ／ Servo test

SERVO

Function
The servo display/servo test function displays the
CH1 to CH6 servo output bar graph and tests servo
operation.
●The servo display function can be used for a simple
operation check of such functions as the mixing
function.
●When the servo test function is turned on, the servo
moves to the left and right at the set period. A
Method
Calling the setting screen
① Call the menu screen from the
home screen by pressing the + key
for 1 second.
＋
(Servo Monitor）
● Select the setting item
with the Jog key.
(Servo Test）
Servo test ON/OFF
Channel Select
Servo test
■ Type/cycle/speed setting
① Select the setting item (TYPE, CYCL,
SPD) with the Jog key and set the item
by pressing the + key or – key.
＋
（Range ／ Default）
TYPE：LNR, JMP ／ LNR
CYCL：1 ～ 100 ／ 10（full speed at 1）
SPD：1 ～ 100 ／ 7（full speed at 100）
72
② Select
from the menu with the Jog
（1 second）
■ Channel selection
② Select the channel you want to
－
or
variable speed LNR (linear) mode or fixed speed
JMP (jump) mode can be selected. This can be
used to check the servo, etc. Operation ON/OFF
can also be selected for each channel.
CAUTION
Using the servo test will move the servos to
their full throw. Do not use this with linkages
installed. Using it may damage the servo and
linkage.
"SERVO"
key.
test with the Jog key and select
ACT/INH by pressing the + key
or – key.
＋ －
or
Selection range：ACT, INH
Default：INH （only CH1 is ACT）
(Common)
③ Open the setting screen by
pressing the Jog key.
Switching to the servo test
screen
● Switch the screen by selecting
TEST and operating the jog
key to the left and right.
● The servo operating position
of each channel is displayed
on a bar graph.
Screen change
● Where "GRPH" is chosen, a
Jog key is pressed in right or
left.
Type Select
Cycle Select
Speed setting
● Operation of a servo test
■ Servo test start/stop
③ Select the "TEST" item
w i t h t h e J o g k e y a n d
start/stop the servo test
by pressing the + key or –
key.
＋ －
or
Selection range：ON, OFF
Default：OFF