How To Use The Service Utility; Starting The Service Utility - Epson AcuLaser C1900 Service Manual

EPSON AcuLaser C1900/AcuLaser C900

5.3.2 How to Use the Service Utility

This section describes how to use this service utility.

5.3.2.1 Starting the Service Utility

1. Double click the icon for this service utility (STA3HBC.exe) to start it.
Figure 5-1. Icon for Service Utility
2. The PC where the service utility is started will display the printer select window based
on the printer driver information installed on the PC. Select "AcuLaser C900" and
click the [OK] button.
Figure 5-2. Printer Select Window
Adjustment
After the [OK] button is clicked, the PC checks for connection to the selected printer. If
the PC has failed in connection to the selected printer, the screen will display the error
message as shown below. Then click the [OK] button, and the service utility will be
terminated.
Possible causes of this error are as listed below. Make certain that the PC and the
printer are connected properly, and then start the service utility again.
The power to the printer is not turned on.
The cable is not connected properly.
The printer you have selected is not AcuLaser C900.
Service Utility (AcuLaser C900)
Figure 5-3. If Failed in Connection
Revision B
213